Installing the radiator in a Ford Windstar isn’t as difficult a job as it might seem. Be certain that the radiator is installed firmly in the correct house and that the rubber mounts on the bottom are supporting the radiator properly. Check the hoses and lines that run to the radiator before it is reinstalled and change any which might be worn. This may save some time and trouble within the future. No special instruments are required.
Ford Windstar Radiator Installation Instructions
1. Set the parking brake and ensure the car is stable. Open the hood and position the radiator in the engine cavity in the entrance of the vehicle. Reposition the clips that hold the radiator and the AC condenser.
2. Use the ten mm socket and ratchet to put in the mounting bolts in the AC condenser.
3. Install the radiator help panel and insert the mounting bolts utilizing the identical socket and ratchet.
4. Set up the bracket on each side of the grille opening panel. Insert the bolts that had been eliminated with the 10mm socket. Install the headlights and switch signals in the event that they had been removed. Not all models require this step.
5. Reconnect the upper and decrease radiator hoses using the channel lock pliers. Reconnect the transmission cooler lines and reinstall the coolant reservoir.
6. Install the fan and shroud assembly and then set up the hood latch by inserting the bolts.
7. Refill the radiator and the reservoir with the required quantity of coolant. Two to 3 gallons ought to be sufficient.